top of page

Permanent, Traceable Marking for Medical and Scientific Components

Oct 27
1 min read

Medical device and laboratory instrument manufacturers need marks that stay readable through sterilisation, cleaning and years of use. Fimark has produced them since 1999.
















THE CHALLENGE

Medical devices, surgical instruments and laboratory equipment carry a lot of information on very little surface: UDI codes, DataMatrix codes, serial numbers, batch codes and regulatory marks.


Those marks have to be:

•     Permanent, and still scannable after autoclaving, passivation and repeated cleaning

•     Applied without damaging the surface or the biocompatibility of the material

•     Traceable to a manufacturer and material batch, with the paperwork to prove it

•     Accurate on small, curved or delicate geometries, including implants


A mark that fades, blurs or damages the part is a compliance risk, not just a cosmetic fault.













WHAT WE DO

We laser mark and deep etch medical and scientific components, for both small batches and production runs.


  • UDI and DataMatrix marking on device components and surgical instruments, in line with EU MDR and US FDA UDI requirements.


  • Serialisation and batch coding so every part can be traced.


  • Regulatory and identification marks, including CE marking and user information, on instruments, consumables and components.


  • Deep etching where a mark has to survive harsh handling or heavy use.


  • Batch documentation and audit support to back up every job.


HOW WE SOLVE IT

Non-contact marking. The laser never touches the part, so there is no tool pressure or distortion. That makes it suited to curved and delicate implant geometries.

bottom of page